Dear fellow BMW enthusiasts, With my deepest respect to you all..
I own a BMW e36 320 M52B20 Sedan.
Last year
We completely replaced the analog-controlled central heating boiler, which was in very poor condition.
At the moment my heater had a hot/cold horizontal potentiometer located in the front-center grille duct.
But, new boiler we installed didn't have a socket hole for a hot-cold potentiometer. ( There is no socket to plug it in.)
I connected the other sockets to the analog control panel for the controls.
The hot-cold horizontal potentiometer cable located on the center grille was left disconnected.
My car chassis number : FC83864
Mounted on Boiler label installed: 94.651.10.000 E36 6411 8.362.392
Mounted on Analog panel controller : 64111387340
And now ;
1- The fan is working but there's no heat.
2- The right front and up side isn't blowing air at all. The left-up side is blowing air.
3-The front center and side grilles produce very little airflow, almost none at all.
4-No hot blowing.
5- When the heater is turned on and off, the servo vanes make a "whirr whirr whirt" sound. But the airflow only reaches the feet, feeling cold. That's all.
Just in case, I also bought a digital climate control panel. It's sitting in my storage room. ( 64118361832 )
And now, how can I fix this heater?
What modifications should I make?
I have a long history of knowledge in electricity and electronics, so you can easily answer.
I am grateful in advance for all your valuable responses.
